Shimano FH-MT200-B 141mm Rear hub

Add this hub to your bench

Hub Data
Manufacturer Shimano
Model FH-MT200-B
Position Rear
Axle Type 10mm
OLN 141 mm
Spoke Interface Type J-Bend
Brake Compatibility disc, Centerlock
Drive Interface Shimano 8/9/10/DynaSys (34.95mm)
Internal Gearing none
Dynamo Type none
Spoke Hole Diameter 2.6 mm
Left Flange Diameter 45.3 mm
Right Flange Diameter 45.3 mm
Left Flange Offset 36.9 mm
Right Flange Offset 23.6 mm
Mid-Flange Offset -6.7 mm (to the left)
Weight 403 g
Hub ID 664
Record Status Public
Created May 8, 2020 10:24pm
Approved Oct 7, 2020 7:31am
hub dimension diagram
PLEASE NOTE: Shimano publishes hub dimensions in a relatively confusing manner on They seem to provide the outside-to-outside flange spacing, and an overall offset of the flanges as a whole. Wheelbuilders are interested in the distance from the midpoint between locknut faces to the middle of the flange (not the inside or outside face). When necessary, I convert Shimano's data into useful spoke calculation dimensions with some simple arithmetic, and factor in 3mm thick hub flanges (an approximation). The formula is to divide spacing by two, add or subtract the overall offset, then subtract half of our assumed 3mm flange thickness. Please check the notes to see if the values for this part are derived from Shimano's published data or actual measurements of a hub specimen. -Karl
10/7/2020 -- This is a boost hub for non-thru-axle frames (148-7=141). Dims tweaked slightly to better match published values. -Karl