Chosen Tandem 145mm Rear hub
Hub Data | ||
---|---|---|
Manufacturer | Chosen | |
Model | Tandem | |
Descriptor | ||
Position | Rear | |
Axle Type | 10mm | |
OLN | 145 mm | |
Spoke Interface Type | J-Bend | |
Brake Compatibility | drum, thread-on | |
Drive Interface | Shimano 8/9/10/DynaSys (34.95mm) | |
Internal Gearing | none | |
Dynamo Type | none | |
Spoke Hole Diameter | 2.7 mm | |
Left Flange Diameter | 62 mm | |
Right Flange Diameter | 62 mm | |
Left Flange Offset | 31.5 mm | |
Right Flange Offset | 22.5 mm | |
Mid-Flange Offset | -4.5 mm (to the left) | |
Weight | 508 g | |
URL |
Metadata | ||
---|---|---|
Hub ID | 554 | |
Record Status | Public | |
Created | Oct 16, 2019 1:15pm | |
Contributed By | Karl Stoerzinger |
10/16/2019 -- Measured used hub during a wheel rebuild. 3-pawl ratchet. Hub uses four 6001 cartridge bearings with a shouldered 12mm steel axle. Freehub has no outer race spacer; only an inner race spacer (press very carefully when installing second bearing).
40.5mm locknut to reg face on freehub body.
33.5mm locknut to reg face on drum threads. 10mm of thread length.
2.65mm plain spacer (to take the place of drum brake when not used) capped with a 6.7mm knurled spacer that touches the dropout, with set screw to bite axle for retention.
40.5mm locknut to reg face on freehub body.
33.5mm locknut to reg face on drum threads. 10mm of thread length.
2.65mm plain spacer (to take the place of drum brake when not used) capped with a 6.7mm knurled spacer that touches the dropout, with set screw to bite axle for retention.