Novatec D041SB-15 100mm Front hub
| Hub Data | ||
|---|---|---|
| Manufacturer | Novatec | |
| Model | D041SB-15 | |
| Descriptor | ||
| Position | Front | |
| Axle Type | 15mm thru | |
| OLN | 100 mm | |
| Spoke Interface Type | J-Bend | |
| Brake Compatibility | disc, 6-bolt | |
| Drive Interface | n/a (front) | |
| Internal Gearing | none | |
| Dynamo Type | none | |
| Spoke Hole Diameter | 2.6 mm | |
| Left Flange Diameter | 58 mm | |
| Right Flange Diameter | 58 mm | |
| Left Flange Offset | 22 mm | |
| Right Flange Offset | 36.5 mm | |
| Mid-Flange Offset | 7.3 mm (to the right) | |
| Weight | 194 g | |
| URL | http://www.nguide.eu/hubs/d041sb-15 | |
| Metadata | ||
|---|---|---|
| Hub ID | 841 | |
| Record Status | Public | |
| Created | Jan 21, 2021 11:04am | |
1/21/2021 -- Measured on an intact front wheel of a Tern HSD. (therefore no weight taken, and the spoke hole diameter is an assumption based on similar hubs). Note that flange-to-flange dimension on the linked page is outside-to-outside rather than center-to-center. -Karl
4/18/2022 -- Measured another hub from a Tern during a wheel rebuild. Holes are indeed 2.6mm. Weight is 194g on this used specimen. Flange diameters and offsets were great, but I did adjust right offset 0.5mm wider after measuring this hub. -Karl
4/18/2022 -- Measured another hub from a Tern during a wheel rebuild. Holes are indeed 2.6mm. Weight is 194g on this used specimen. Flange diameters and offsets were great, but I did adjust right offset 0.5mm wider after measuring this hub. -Karl