DT Swiss 240s 20/15 100mm Front hub
| Hub Data | ||
|---|---|---|
| Manufacturer | DT Swiss | |
| Model | 240s 20/15 | |
| Descriptor | ||
| Position | Front | |
| Axle Type | 15mm thru | |
| OLN | 100 mm | |
| Spoke Interface Type | J-Bend | |
| Brake Compatibility | disc, 6-bolt | |
| Drive Interface | n/a (front) | |
| Internal Gearing | none | |
| Dynamo Type | none | |
| Spoke Hole Diameter | 2.4 mm | |
| Left Flange Diameter | 58 mm | |
| Right Flange Diameter | 52 mm | |
| Left Flange Offset | 22.1 mm | |
| Right Flange Offset | 30.3 mm | |
| Mid-Flange Offset | 4.1 mm (to the right) | |
| Weight | 165 g | |
| URL | ||
| Metadata | ||
|---|---|---|
| Hub ID | 443 | |
| Record Status | Public | |
| Created | Feb 16, 2019 5:28pm | |
Anonymous contrib. See HU0568 & HU0569. 15x100 hub: endcaps are threaded (appears to be approximately M25x1 threading) and have a pair of machined wrench flats for a 22mm cone wrench. Right endcap has a stack height of 15.5mm. I didn't remove the left endcap to measure. This hub is convertible to 20x110 using DT p/n HWGXXX00S4470S or HWYXXX00S2477S.
I would be interested in getting confirmation on the smaller-than-usual hole diameter of 2.4mm entered by the submitter. -Karl
I would be interested in getting confirmation on the smaller-than-usual hole diameter of 2.4mm entered by the submitter. -Karl