Hope Pro 2 Evo Fatsno (rear disc offset) 135mm Front hub
Hub Data | ||
---|---|---|
Manufacturer | Hope | |
Model | Pro 2 Evo Fatsno (rear disc offset) | |
Descriptor | ||
Position | Front | |
Axle Type | 10mm | |
OLN | 135 mm | |
Spoke Interface Type | J-Bend | |
Brake Compatibility | disc, 6-bolt | |
Drive Interface | n/a (front) | |
Internal Gearing | none | |
Dynamo Type | none | |
Spoke Hole Diameter | 2.6 mm | |
Left Flange Diameter | 56 mm | |
Right Flange Diameter | 54 mm | |
Left Flange Offset | 32.9 mm | |
Right Flange Offset | 38.4 mm | |
Mid-Flange Offset | 2.8 mm (to the right) | |
Weight | 0 g | |
URL | http://www.hopetech.com/page.aspx?itemid... |
Metadata | ||
---|---|---|
Hub ID | 241 | |
Record Status | Public | |
Created | Nov 16, 2012 1:52pm |
11/16/12 -- Dimensions sent in by Van Phifer c/o Hope Tech. Note that this is a "front" fatbike hub that uses a 10x135 axle (typical mountain rear) and a "rear" ISO disc brake mount spec. -Karl
These measurements are of a hub from ~2012, before hubs were marked with FDS or RDS. I don't know if any changes to flange diameters or spacing happened since then, so check your dimensions carefully. Note that the FDS hub in this database has different flange diameters and a different left offset than this hub.... -Karl
These measurements are of a hub from ~2012, before hubs were marked with FDS or RDS. I don't know if any changes to flange diameters or spacing happened since then, so check your dimensions carefully. Note that the FDS hub in this database has different flange diameters and a different left offset than this hub.... -Karl